-
Sign Up! To view all forums and unlock additional cool features
Welcome to the #1 Explorer ST Forum and Explorer ST community dedicated to Explorer ST owners and enthusiasts. Register for an account, it's free and it's easy, so don't hesitate to join the Explorer ST Forum today!
Dirty Dan Build
- Thread starter Crisisballer17
- Start date
OP
Thread Starter
#24
OP
Thread Starter
#25
Mbrp sounds great!!!, just did dual port turbosmart bov, the little wiring pigtail that is on it was assembled poorly, and when I went to zip tie it after install the pig tail came out of plug, and the wire loom came apart, I am sure I just got a bad one. But when you do your bov, just treat the wire pigtail very delicate
-
1
- Show All
OP
Thread Starter
#29
Thread Starter
#29
The exhaust system sounds great still. Just finished a 1,500 mile road trip with no complaints. Minor drone at certain RPM bands.
The only thing I'll say is, the (8) exhaust clamps that came with the system were very poorly constructed. I assume due to the current market availability of more premium type products. They did not snug the piping well enough and there was movement, especially around the x pipe, that caused rattling between the x pipe hanger and the chassis at lower RPM/idle.
I replaced all of the hangers with much better built polished stainless steel pieces. Cost me roughly $100 out of pocket for new clamps, but well worth it.
That being said, I'm very happy with the system so far.
The only thing I'll say is, the (8) exhaust clamps that came with the system were very poorly constructed. I assume due to the current market availability of more premium type products. They did not snug the piping well enough and there was movement, especially around the x pipe, that caused rattling between the x pipe hanger and the chassis at lower RPM/idle.
I replaced all of the hangers with much better built polished stainless steel pieces. Cost me roughly $100 out of pocket for new clamps, but well worth it.
That being said, I'm very happy with the system so far.
Last edited:
OP
Thread Starter
#34
OP
Thread Starter
#35
Thread Starter
#35
Steeda parts "Out for Delivery", YAY!
Pics of the before/after Steeda parts later this evening.
DIY partial hood wrap didn't go well. I tried. It's way harder to do than people think, with the center hood depression area. That being said, I have an appointment on July 15th for the pros to wrap the hood.
Pics of the before/after Steeda parts later this evening.
DIY partial hood wrap didn't go well. I tried. It's way harder to do than people think, with the center hood depression area. That being said, I have an appointment on July 15th for the pros to wrap the hood.
OP
Thread Starter
#37
OP
Thread Starter
#38
