Search results

Another good idea is to get a clay mitt. Helps really decontaminate the paint after you wash. Do a good washing to get the dirt off then resoap it with your foam sprayer and use the clay mitt. Works great! Sent from my iPhone using Tapatalk

They also have a great wheel/tire cleaner. Does both at the same time. P&S Brakebuster. Works great in a foam gun too. Sent from my iPhone using Tapatalk

Looks great by the way. Sent from my iPhone using Tapatalk

P&S Beadmaker as a drying agent or spray on wipe off after a wash really makes it pop. Works on everything. Windows, rims, and paint. It’s cheap too. Sent from my iPhone using Tapatalk

I am keeping mine in case I resell it and someone wants them. They will go in the attic. I have a hard time throwing stuff away because the minute you do, you need it. Sent from my iPhone using Tapatalk

Anyone figure this out yet? I use this to Jack it up in the properly designated locations but not sure where to place front Jack stand. I raise both wheels on one side off the ground using just the front jacking point. I place a Jack stand with a pinch weld protector under the rear designated...

I like that. Is that a pretty easy install? Do you have the link to the sub? Sent from my iPhone using Tapatalk

Nice. I like it. Sent from my iPhone using Tapatalk

Looks like they made significant changes. Check out the original bar that I was sold compared to the stock bar. Sent from my iPhone using Tapatalk

Here’s the email. Sent from my iPhone using Tapatalk

It’s 150 per Bora. Sent from my iPhone using Tapatalk

Yes. Both. Sent from my iPhone using Tapatalk

1.25 all the way around and no shaving of studs. Easy job once it’s jacked up. Sent from my iPhone using Tapatalk

No issues at all. Emailed me and said 150. Sent from my iPhone using Tapatalk

I used a floor Jack with a special round pinch weld puck. I guess it was too wide. I just ordered a more narrow one. Hope that works better. Sent from my iPhone using Tapatalk

Thanks. I will still keep to the right side of the road and let the Porches, Mercedes, and BMWs fly by. It will still be a lot of fun though. Sent from my iPhone using Tapatalk

The issue is with the stock springs and the Steeda sway bar. No problem if you change both but I was doing this a little at a time. Sent from my iPhone using Tapatalk

Makes sense. Looking forward to the Steeda springs to finish it off. Then off to the Nurburgring. Sent from my iPhone using Tapatalk

I removed my wheels today and even by lifting in the correct spot, it bent the plastic. Had to mold it back into shape. Just have to be careful not to put on pressure near the plastic pieces. Lessons learned. Sent from my iPhone using Tapatalk

Just installed my spacers and it looks so much better. I think it handles better too but hard to tell. I saw someone posted a question about how to keep the front rotors from spinning while torquing so I figured I would share what I did. Didn’t have anyone to hold the break so I had to improvise...