Search results

I decided not to cut mine. I’ll wait to see what Steeda says. Just took it for a drive without the stock one on and you can tell the difference. Unfortunately, all the mods I’ve done, except for the ZFG Racing Tune, has had issues. First the Steeda and now the Borla throwing fibers everywhere. I...

Exactly. It’s angled in too much at the ends. Sent from my iPhone using Tapatalk

I took off the Steeda sway bar and compared it to my stock one. The stock one is almost an over an inch wider. Sent from my iPhone using Tapatalk

Under the vehicle now. The first pic is the left side and the second pic is the right side. Left is hitting. There isn’t hardly any space on the right side to even shift it over to the left. Sent from my iPhone using Tapatalk

That makes no sense. How about stock springs. That’s what I have. Unless they want to give me a free set of Steeda springs. Sent from my iPhone using Tapatalk

I think they will replace them if pressed. However, I don’t have the patience to wait for international shipping and it’s rubbing now. Just pulled it up on ramps to try and fix it again. I’ll probably just cut the end hole off. Sent from my iPhone using Tapatalk

Thank you. I like the sound now but curious what yours sounds like. Sent from my iPhone using Tapatalk

Cool, thanks. I am in Germany so hopefully they don’t want me to send the old ones back. It will cost them or me. We shall see. Sent from my iPhone using Tapatalk

They also replied and said they make them so close to the springs to allow for wider tires. Sent from my iPhone using Tapatalk

I am in contact with Borla now. They asked for pics and my receipt. Not sure what is next. Sent from my iPhone using Tapatalk

I don’t either. I just hate paying for something that doesn’t work properly not to mention my time and effort. You would think they would figure this out on their end. Sent from my iPhone using Tapatalk

Yes I am working with Steeda now. I have to remove mine and provide them with measurements. Mine is hitting the stock springs. Sent from my iPhone using Tapatalk

I am working with Steeda now regarding my sway bar. I’ve had to loosen and adjust it three times now. It moves when taking a hard corner because flanges aren’t tight against the bushings and the ends are way to close to the springs. They want me to remove it and provide them with measurements. I...

Wow. Looks sharp! Sent from my iPhone using Tapatalk

Thanks for doing the legwork. Mine is doing the same thing. Sent from my iPhone using Tapatalk

I spoke with Steeda and they want me to remove it and take measurements between the outside ends and the inner flanges. I’ll also compare it to the stock one. Sent from my iPhone using Tapatalk

I have mine in the middle. I’m not towing a boat now but may later. Definitely not off roading. It still bothers me that the bar slides from side to side. To me, that would reduce the performance and may eventually where out the bushings. Who knows. Maybe Steeda will just replace it. Sent...

Yes I noticed that and they won’t respond to my emails either. Sent from my iPhone using Tapatalk

Would probably be pretty tough to do with a reciprocal saw but that’s all I have now. Germany has 220v so all my 110v tools are worthless now. Sent from my iPhone using Tapatalk

Yea I’m at a loss. Was considering cutting off the ends since I’ll never use them. Shouldn’t have to though. Sent from my iPhone using Tapatalk