Search results

what are the common socket/wrench sizes needed to install these springs? I don't want to start pulling stuff off then realize I need a different size socket LOL

sadly I haven't installed yet LOL my wife rear-ended another vehicle which paused updates for a bit, the collision company wouldn't touch mods - so I had them redo the front bumper i'll have to take it all off to mount these, plus my bigger intercooler - so - on pause for now

btw finally got this installed - great unit! was pretty simple installation as well - took maybe an hour ;)

different quality metal as well - some aftermarket vendors do have a weep hole...

also, as some mentioned - a weep hole will most likely deposit 'crud' on your garage floor or driveway... most likely will stain, so take that into account - when you drive away, your neighbors will think you have a hooptie dripping some type of crud

did anyone ask Thermal about this? maybe there are weep holes but on the wrong side? e.g. mufflers upside down? at least everyone knows their catalytic converters are working properly - making muffler juice :)

yep! Larry was great!

she was so bummed not breaking into the 20s but she won the cone! (y)

my wife's first pass run, she ended up at 30.053 - so close to sub-30 second runs... such a blast, well worth the time :)

have you reached out to the seller for instructions?

found a good install video :)

so how do you 'notice' the change? curious on these parts - they make sense, but what's the difference to stock? is there an install guide?

yeah, was thinking gorilla tape with a wide base of about 2" square to hold it - but maybe need to figure out how to screw mount it into the case?

just FYI - the bulletpoint suction cup is WAY too big for the back of the screen, having my son 3D print a 20mm ball that I can mount with gorilla tape to see if that is strong enough for the mount :)

ended up ordering their suction cup mount (which I hope will attach to the back of the screen) and the Bulletpoint XL Dash Mount Cell Phone Holder for Oversized Phones this paired with a 7cm CF arm should give enough clearance to the vent but not be too high either hoping for a setup like...

Unsure of the blinker tie in - would want to tie into the turn signal flashers though

I’m sure it can stay in place - just have to place the strip in front of the seal - honestly I was just doing a quick setup and ripped the seal out

found this mount, maybe able to determine how long of an arm to mount the iphone to extend to the left of the vertical screen, they have a 4cm and 7cm arm...

we've tried the lower mount by the cupholders, and the 3d printed one with the dragy mount, both aren't cutting it I thought maybe a mount that suction cup mounted to the back of the vertical screen may give a new option my wife doesn't want a vent-mount version any success in these types of...

I think a lot of replacing the existing sub is getting to it... IMHO there's a lot to remove to get to it