Search results

this is what sets a lot of ford vehicles apart from the rest. this is an envaluable feature.

so i guess i didnt follow when you were in forscan. you saved the stock config, installed the part then reloaded the stock config again? what did you change in Forscan?

give service a quick call and see ‍♂️

its crazy how trivial this is but how much I want it...hmm @locoliberty where did you buy from?

ive noticed more of the issues and that seems to happed with the weather changing and getting colder it is not as responsive. I did notice my keypad not being as responsive as well even in warmer weather but not sure if they have to do with each other.

hey fellow Sacramentan! its been pissing rain the last few weeks here and cold. have you tried when it was a bit warmer and not wet?

I have a buddy with both the Mk3 and the smaller prusa and im constantly inpressed with his prints. absolutely beautiful with a pretty much plug and play design. I have a basic ender 3 that does alright but I have to nut up for the cost of the Prusa but have been a little gun shy

or have it and maybe help a fellow forum member out on a discounted control ;)

not sure if you saw my earlier post of my experience but its fairly easy to get the part from your local dealer. check below https://www.explorerst.org/threads/rear-climate-control-dealer-paid-and-installed.4678/

check out my thread of how i was able to get mine. https://www.explorerst.org/threads/rear-climate-control-dealer-paid-and-installed.4678/

ive had the rough shifts in Normal mode as well from 3-4. in sport more so and it kinda makes me cringe just a little.

agree with this. 75-85 has a small drone but turn up the radio a bit and its gone

So I thought id post up my experience with getting the dealer to pay for and install the rear climate controls, here is my story: After reading about folks on here getting their own climate controls for the rear passengers on their own i decided to go ahead and follow suit and purchase my own...

oohh...carbon PETG? that sound fancy. ive used a few PETG prints in the engine bay and have had ok success but not carbon. Wonder if that would hold up better. well done in the build btw.

what are you using to print these? I wouldnt think PETG could stand up to summer temps

in to see if this works...

I think you might be into something there... each time it's happened to me was right around 5-10mins turning the car on coldish. I did a hard pull from a dig and didn't have any issues after it's been running a bit

Can't he see the missed shifts in the logs though? You would think he could see what the trans is doing at each pull

Well that's disheartening that Adam didn't see the failure in the logs

Did you get the same error on your app?