Search results

Sent from my iPhone using Tapatalk

We would like to get a serious headcount on this. Please let me know and message me or @Waido on this Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Roughy 2k the mold needs to be made so we need at least 3 to 4 ppl to be interested with half down before moving forward Sent from my iPhone using Tapatalk

This is the last rendering .. classic clean look following the lines of the current body. Sent from my iPhone using Tapatalk

Right side and push it hard. *** Sent from my iPhone using Tapatalk

The left side looks released. Now try and located the spring on the left side and push it hard . It “should” pop out. If not I don’t know man. Took a few tries the first time. Sent from my iPhone using Tapatalk

Sounds like one is still locked in place. It may seem unlocked but not. Take a picture ? If it’s not going back in something is out of place. Sent from my iPhone using Tapatalk

It needs to be long enough to reach the spring and you have to push pretty hard. It’s only 2 holes. One on each side. Releasing one is easy once you located the spring loader. Once you feel it pop out a little go to the other side and press in hard on that spring and the whole airbag will move...

Last rendering is coming today .. no vents Sent from my iPhone using Tapatalk

Newest renders . I think this nails it Sent from my iPhone using Tapatalk

Not rapid red but you get the picture and the new design. Brought the kit down some and added the vent on the front. Super clean look Sent from my iPhone using Tapatalk

There won’t be any reduction in the gap area. Sent from my iPhone using Tapatalk

Agreed and it’s ONLY renderings … in person is a different story. Most likely looks 10x better Sent from my iPhone using Tapatalk

Nothing from the last renders hav changed just the wheels and tires … no one has stretched tires Sent from my iPhone using Tapatalk

More renderings with a better angle to show the flare and a better sidewall on the tire. I know we will not satisfy everyone but let’s start getting a head count together. Sent from my iPhone using Tapatalk

Custom wheel :) Would need to figure out the perfect offset Sent from my iPhone using Tapatalk

1.25 spacer on 22x10.5 with +30 would be flush. If you have the oem set up you would need rough 2.5 spacer to be flush and that is a lot of spacer. Cost is going to be roughly 2k before shipping Sent from my iPhone using Tapatalk

Thank you. I plan on a dyno run On E50 before and after install if my shop gets their 4WD dyno next month. Sent from my iPhone using Tapatalk

It’s really hard to say to be honest. We have 25K on them now but it’s mainly the rear tires due to the obnoxious snow storms in TEXAS earlier this year and getting stuck in a foot of snow spinning out in a construction zone. Sled right into a 45 degrees ditch. Embarrassing to say the least...