Has anyone done Bora spacers?

[Ncavalin78]

Wondering if you had to shorten the existing studs to get them to work. I have 1”

 

[gkmunch]

Anything under 1.25”, you’ll have to trim the studs. I just ordered 1” front, 1.25” rear. Lots of guys run 1.25” all around it seems.


Sent from my iPhone using Tapatalk

 

[tengelman83]

Yep, 1.25" rears required no trim. My .75" front needed .5" trimmed off the studs

 

[Jahblessd]

Just ordered 1.25 front and 1.5 rears last night. Looking forward to these being installed.

 

[ARC]

I did the 1.25 on the rear with no issues.
I want to order 1inch for the front and I think they will work w/o a trim?
Has anyone tried 1inch on the front.

 

[Jahblessd]

I did the 1.25 on the rear with no issues.
I want to order 1inch for the front and I think they will work w/o a trim?
Has anyone tried 1inch on the front.

You'll have to trim anything less than 1.25 front.

 

[ARC]

Yep, 1.25" rears required no trim. My .75" front needed .5" trimmed off the studs

So I wonder if 1 inch spacers will work without trimming?

 

[gkmunch]

So I wonder if 1 inch spacers will work without trimming?

I think anything less than 1.25” requires trimming.

I nipped .25” off my fronts to accommodate 1” Bora spacers.


Sent from my iPhone using Tapatalk

 

[Mikes 22St]

I did the 1.25 on the rear with no issues.
I want to order 1inch for the front and I think they will work w/o a trim?
Has anyone tried 1inch on the front.

I had to trim my fronts with 1" n did 1.25" on rears without trimming..

 

[nikolai9956]

I ran 3/4 front and 1 rear. Had to trim both to work with stock 21" st wheels. Upgrading wheels now and had to replace front studs to have enough thread for the new wheels (easy job). I tried 1" front and 1.25" rear originally and didn't like all the crap being kicked up by the edge of the tires. In my opinion 3/4F 1R gives you the most flush look with stock 21 wheels and tires.