Mass_ST Build Thread

[Mass_ST]

Starting the build on my 2020 ST with lowering springs from Eibach.



Before lowering:

Front - 33.25” ground to fender


Rear - 33.5”


After Lowering:

Front - 31.25”


Rear - 31.75”


Needs a wash but profile picture:

 

[BrooseDaMoose]

Looks Good! Are you in the Boston area? I'm down in SE Mass around Fall River.

 

[STJIM]

Starting the build on my 2020 ST with lowering springs from Eibach.

View attachment 25226

Before lowering:

Front - 33.25” ground to fender
View attachment 25224

Rear - 33.5”
View attachment 25225

After Lowering:

Front - 31.25”
View attachment 25227

Rear - 31.75”
View attachment 25228

Needs a wash but profile picture:
View attachment 25229


View attachment 25230

View attachment 25231

Nice pics! Just a suggestion, if you could take your measurements from the hub center to the wheel lip edge that will give everyone no matter what wheel/tire combo they’re running the same measurement. Thanks!

 

[Mass_ST]

Looks Good! Are you in the Boston area? I'm down in SE Mass around Fall River.

SE Mass too! I’m around Foxboro area near Gillette.

 

[BrooseDaMoose]

SE Mass too! I’m around Foxboro area near Gillette.

You’re only about 20 minutes from me. We should meet up some time.


Sent from my iPhone using Tapatalk

 

[Mass_ST]

You’re only about 20 minutes from me. We should meet up some time.


Sent from my iPhone using Tapatalk

Definitely! We should get a SE Mass meet going.

 

[21BlackST]

Looks good man. I’m just over the border in NH. Roughly an hour or so from Gillette. I have H&R’s sitting on my garage floor. I’m just lazy.

 

[Mass_ST]

Looks good man. I’m just over the border in NH. Roughly an hour or so from Gillette. I have H&R’s sitting on my garage floor. I’m just lazy.

The rears are a bitch so just be prepared for that. Outcome is worth the aggravation though.