Need wiring help

[StoneColdBlue22]

Hi all,
I recently purchased a prosport gauge and need a source of constant 12v, accessory 12v, and a 12v headlight lead for the dimming function.
Ill start a thread once i get around to installing it incase anyone wants to do something similar.

 

[StoneColdBlue22]

 

[Jeppo]

I believe I lifted this from a dash cam install thread here. I followed it for my install (although I conserved the original fuses and used very low amperage fuses to feed the camera). Not sure where you’ll find the dimmed light power.

 

[StoneColdBlue22]

progress is slow but steady, havent had much time to really dedicate to the ST these past days, i have the vacuum line run, the pressure transducer mounted, just trying to pass the wiring through the firewall.

i temporarily ran the line inside the cabin and attached the gauge to a 9v battery as shown, only problem is.... as full load im only getting 12 or so psi, not sure if thats normal.

 

[CCS86]

progress is slow but steady, havent had much time to really dedicate to the ST these past days, i have the vacuum line run, the pressure transducer mounted, just trying to pass the wiring through the firewall.

i temporarily ran the line inside the cabin and attached the gauge to a 9v battery as shown, only problem is.... as full load im only getting 12 or so psi, not sure if thats normal.

Did you ever find illumination power?